
FSW-21F-CM Series
Industrial 2-port 10/100Base-TX to 100Base-FX Switch
V3 1
This quick start guide describes how to install and use the Industrial Switch. This is the Switch introduced here provides two port 10/100Base-TX
to 100Base-FX.
Physical Description
The 100Base-FX connections and Power inputs
Front and rear panel of FS
-21F-YY-
The fiber port(s) for 100Base-FX connections
FSW-21
-YY-
Standalone Unit (FSW-21F-SA-X)
The 100Base-FX Connections
The TX (transmit) port of device I is connected to the RX (receive) port of
device II, and
the RX (receive) port of device I to the TX (transmit) port of device II.
Front panel
value:
A for Multimode fiber
B for Singlemode fiber
FIBER Connector
TX SC Optical Connector
RX SC Optical Connecto
Rear Panel
Power Input Assignment-DC Jack
value:
G for Multimode fiber
H for Singlemode fiber
FIBER Connector
TX ST Optical Connector
RX ST Optical Connecto
Card Module (FSW-21F-CM-X)
Power Input by build-in NC-PSU/5V in NC-R12
The WDM 100Base-FX Connections
Only one single-mode optical fiber is required to transmit and receive data.
Front panel
Rear Panel
X value:
C and D for Multimode fiber
H and F for Singlemode fiber
FIBER
Connector
SC Optical Connector
value:
I and J for Multimode fiber
K and L for Singlemode fiber
FIBER
Connector
ST Optical Connector
Commentaires sur ces manuels